Publications

[NOT AVAILABLE]J.W. Bruce, "Design Methodology Suitable for Team-based Embedded Systems Education", ASEE Computers in Education Journal, vol. 14, no. 3, pp. 41-54,  July 2004. 

 

[NOT AVAILABLE]J.W. Bruce and L.A. Hathcock, "Maintenance and Monitoring Object Models for High-Availability Network Appliances", IEEE Trans.  on Consumer Electronics, vol. 50, no. 2, pp. 472-477,  May 2004. 

 

[NOT AVAILABLE]J.W. Bruce, J.C. Harden, and R.B. Reese, "Cooperative and Progressive Design Experience for Embedded Systems", IEEE Trans.  on Education, vol. 47, no. 1, pp. 83-92, Feb. 2004. 

 

[NOT AVAILABLE]Michael O. Morgan and J.W. Bruce, "The CRL gateway: A new way to build logic functions", IEEE Potentials, vol. 22, no. 5, pp. 8-11,  Dec. 2003. 

 

[NOT AVAILABLE]J.W. Bruce, M.A. Gray, and R.F. Follett, "Personal Digital Assistant (PDA) Based I2C Bus Analysis", IEEE Trans.  on Consumer Electronics, vol. 49, no. 4, pp. 1482-1487,  Nov. 2003. 

 

[NOT AVAILABLE]J.W. Bruce, "Nyquist-rate digital to analog converter architectures," IEEE Potentials, vol. 20, no. 3, pp. 24-28, August 2001.

 

[NOT AVAILABLE]J.W. Bruce, B. Steadman, and P. Stubberud, "Generalised cube-based dynamic element matching algorithms for digital-to-analogue converters," IEE Electronics Letters, vol. 37, no. 8, pp. 485-487, April 2001.

 

[NOT AVAILABLE] P. Stubberud and J.W. Bruce, "An analysis of dynamic element matching flash digital to analog converters," IEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, vol. 48, no. 2, pp. 205-213, Feb. 2001.

 

[PDF]J.W. Bruce, "Dynamic element matching techniques for data converters," Ph.D. dissertation, Department of Electrical and Computer Engineering, University of Nevada Las Vegas, 2000.
WARNING: This document is very large (4.6MB)

 

[NOT AVAILABLE]J.W. Bruce, "Meeting the analog world challenge: Nyquist rate analog to digital converter architectures," IEEE Potentials, vol. 17, no. 5, pp. 36-39, January 1999.

.


Refereed Conference Proceedings

[NOT AVAILABLE] J.W. Bruce, "Design Inspections and Software Product Metrics in an Embedded Systems Design Course", Proc. of the ASEE Annual Conference and Exposition, Session 1620, Salt Lake City, UT, June 2004.  (Nominated for Best Paper out of 1400+ submissions)
 

[NOT AVAILABLE] L.M. Bruce and J.W. Bruce, "Maximizing Your Productivity as a Junior Faculty Member: Balancing Research, Teaching, and Service", Proc. of the ASEE Annual Conference and Exposition, Session 1475, Salt Lake City, UT, June 2004. 
 

[NOT AVAILABLE] J.W. Bruce and L.M. Bruce, "Maximizing Your Productivity as a Junior Faculty Member: Being Effective in the Classroom", Proc. of the ASEE Annual Conference and Exposition, Session 2275, Salt Lake City, UT, June 2004. 
 

[NOT AVAILABLE] J.W. Bruce, "Design Methodology Suitable for Team-based Embedded Systems Education", Proc. of the ASEE Annual Conference and Exposition, Paper 83, Session 1620, Nashville, TN, June 2003. 
 

[NOT AVAILABLE] J.W. Bruce, J.E. Creekmore, and B.J. Blalock, "Adaptive Design Method for Efficient Direct Digtal Synthesis," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 545-548, Tulsa, Oklahoma, August 2002.
 

[NOT AVAILABLE]J.A. Bell and J.W. Bruce, "CMOS current mode interpolating flash analog to digital converter," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 363-366, Tulsa, Oklahoma, August 2002.
 

[NOT AVAILABLE]J.W. Bruce, M.A. Thornton, L. Shivakumaraiah, P.S. Kokate, and X. Li, "Efficient Adder Circuits Based on a Conservative Reversible Logic Gate," Proc. of the IEEE Computer Society Annual Symposium on VLSI, pp. 83-88, Pittsburgh, Pennsylvania, April 2002.
 

[NOT AVAILABLE]J.A. Bell, J.W. Bruce, B.J. Blalock, and P. Stubberud, "CMOS current mode flash analog to digital converter," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 272-275, Dayton, Ohio, August 2001.
 

[NOT AVAILABLE] J.E. Creekmore, S.R. Porter, J.W. Bruce, and B.J. Blalock, "Direct digital frequency synthesis using nonlinear digital-to-analog conversion," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 897-900, Dayton, Ohio, August 2001.
 

[NOT AVAILABLE]J.W. Bruce and P. Stubberud, "A comparison of hardware efficient dynamic element matching networks for digital to analog converters," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 672-675, East Lansing, Michigan, August 2000.
 

[NOT AVAILABLE] P. Stubberud and J.W. Bruce, "An analysis of dynamic element matching algorithms for analog to digital converters," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 684-687, East Lansing, Michigan, August 2000.
 

[NOT AVAILABLE]J.W. Bruce and P. Stubberud, "An analysis of analog to digital conversion and harmonic distortion," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 656-659, East Lansing, Michigan, August 2000.
 

[PDF]J.W. Bruce and P. Stubberud, "An analysis of harmonic distortion and integral nonlinearity errors in DACs," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 470-473, Las Cruces, New Mexico, August 1999.
 

[PDF] P. Stubberud and J.W. Bruce, "An analysis of stochastic dynamic element matching DACs," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 481-484, Las Cruces, New Mexico, August 1999.
 

[NOT AVAILABLE] P. Stubberud and J.W. Bruce, "A frequency analysis of stochastic dynamic element matching flash digital-to-analog converters," Proc. of the International Conference on Systems Engineering XIV, pp. EE13-18, Las Vegas, Nevada, August 1999.
 

[NOT AVAILABLE] P. Stubberud and J.W. Bruce, "Exposing Undergraduates to Collaborative Engineering Design Teams," Proc. of the Annual Meeting of the ASEE Pacific Southwest Section, pp. 79-86, Las Vegas, Nevada, March 1999.
 

[NOT AVAILABLE]J.W. Bruce and P. Stubberud, "Switching circuit network topologies for dynamic element matching data converters," The 105th Convention of the Audio Engineering Society, (1998 Sept.), preprint 4773.
 

[PDF]J.W. Bruce, P. Stubberud and A. Iyer, " Range estimation and object identification with a single camera machine vision system," Proc. of the International Conference on Systems Engineering XIII, pp. 253-259, Wroclaw, Poland, September 1998.
 

[PDF]J.W. Bruce and P. Stubberud, "Generalized cube networks for implementing dynamic element matching digital-to-analog converters," Proc. of the IEEE Midwest Symposium on Circuits and Systems, pp. 522-525, Notre Dame, Indiana, August 1998.
 

[NOT AVAILABLE] P. Stubberud, J.W. Bruce and B. Steadman, "A DAC architecture with a hardware efficient dynamic element matching network," Proc. of The Second International Workshop on Design of Mixed-Mode Integrated Circuits and Applications, pp. 9-12, Guanajuato, Mexico, July 1998.
 

[PDF] P. Stubberud and J.W. Bruce, "An LMS algorithm for training single layer globally recursive neural networks," Proc. of IEEE Int'l Joint Conference on Neural Networks, pp. 2214-2217, Anchorage, Alaska, May 1998.
 

[NOT AVAILABLE] L.M. Bruce, R.R. Adhami, and J.W. Bruce, "Appropriate scales when using wavelets for feature extraction," Intelligent Engineering Systems Through Artificial Neural Networks vol. 6, Proc. of Artificial Neural Networks in Engineering 1996, (Dagli et al,eds.), St. Louis, Missouri, pp. 507-512, November 1996.
 

[NOT AVAILABLE] L.M. Bruce, R.R. Adhami and J.W. Bruce, "Wavelets for shape recognition with applications to mammography," Intelligent Engineering Systems Through Artificial Neural Network vol. 6, Proc. of Artificial Neural Networks in Engineering 1996, (Dagli et al,eds.), St. Louis, Missouri, pp. 653-658, November 1996.

.


Presentations

[NOT AVAILABLE] "A novel dynamic element matching algorithm for data converters," HRL Laboratories (Hughes/Raytheon), September 1999.
 

[NOT AVAILABLE] "Dynamic element matching techniques for analog-to-digital and digital-to-analog conveters," Conexant Systems (formerly Rockwell Semiconductor), June 1999.
 

[NOT AVAILABLE] "Dynamic element matching techniques for instrumentation and data acquisition," Nevada Symposium on Science and Technology, Las Vegas, Nevada, January 1998.

.


Comments and questions should be directed to

Last updated on .